You may be able to get away without removing the rear seat(s) but I am not sure if you will be able to remove or slide the bottom metal trim out of the way, enough to remove the panel. There will probably be some black adhesive goo (waterproofing) in the holes, just something to watch out for. Classic Industries offers Ford Thunderbird Emblems & Decals. If you have the birds, you can use a panel tool or needle nose pliers to gently remove the barrel nuts. Classic Industries offers a wide selection of Emblems & Decalsfor your Ford Thunderbird. ZIC Motorsports 1957 Ford Thunderbird Emblem Badge Heavy Duty Large Metal Garage Wall Sign - 30' X 6'. If you have landau emblems, they unscrew, 4 nuts. This should expose the backside of the emblem, you may have to move a bit of insulation and tar paper out of the way. Finally, there are 3 clips, holding the panel in place, it just pops off. Then the remove the metal trim, surrounding the interior C pillar panel and the courtesy light. NOS Door Upper Belt Moulding with window wipe rubber -Cars without vent window and sail mirror. So your rear seat bottom, then the seat back(s) need to be removed. 1 Designed as a pony car to compete with the Ford Mustang, it was introduced on February 23, 1967, five months after GM's Chevrolet division's platform-sharing Camaro. The only way they could be removed, from outside of the car, would require breaking the emblems and the tabs etc. The Pontiac Firebird is an American automobile that was built and produced by Pontiac from the 1967 to 2002 model years. I'm not sure if there are any actual 'tricks' to remove them? You will absolutely have to take apart some of your interior to get to the backside of the emblems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |